Track width increases will affect clearance between the tire and the fender.1996-04 spindles will increase the front track width by 0.320" ( 8.1mm) per side.1994-95 spindles will increase the front track width by 0.120" ( 3.1mm) per side.Ride height will not significantly change after mounting a 1994-95 spindle on a Fox chassis front control arm (spring in stock location).Correcting bumpsteer is recommended for any Mustang driven in competition. Assuming that the suspension geometry is otherwise unaltered, this will not cause a significant enough change in bumpsteer to require a bumpsteer kit for a typical street-driven Mustang. 1994-95 spindle on a Fox chassis will change the vertical location of the steering arm by only 0.060" (1.4mm).Stack-up of required bumpsteer spacers would be about 0.96" less with the 1996-04 spindles, resulting in less flexing of the steering arm, which improves steering response.As far as the steering geometry goes, this has the same effect as if the rack was lowered by 1", relative to the control arm pivot points. 1996-04 spindle is a better choice than the 1994-95 spindle because the MM K-member raises the pivot location of the front control arms from the stock position.1996-04 spindles are an excellent choice when using a Maximum Motorsports K-Member on a Fox chassis Mustang.Doing so will prevent insurmountable bumpsteer problems. Stock Fox chassis k-member, or an aftermarket k-member that retains the stock front control arm pivot point vertical location, should use a 1994-95 spindle.It is impossible to correct the geometry with a bumpsteer kit because the outer tie-rod end needs to be raised so much that it would have to occupy the same physical space as the steering arm. ![]() That new position is far too low for the steering rack location of any 1979-93 Mustang, and radically changes the steering geometry.The lower steering arm forces the outer tie-rod end to a lower position. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |